When running CLI commands against an HPE Aruba (previously ProCurve) switch that have long outputs you have likely encountered the line below.

— MORE –, next page: Space, next line: Enter, quit: Control-C

Although handy – on occasion you might need to turn this off. To do so simply run the command (no need to be in config mode for this) below.

no page

Note that this will only turn off paging for the current session so if you log out or reboot the switch you’ll need to run the command again. Equally so to turn paging back on simply run the command below.


VN:F [1.9.22_1171]
Thumbs up if this article helped you 🙂
Rating: +6 (from 6 votes)
HPE ProCurve/Aruba turn off -- MORE -- (aka paging), 100% based on 6 ratings

One Response to HPE ProCurve/Aruba turn off — MORE — (aka paging)

Leave a Reply

Your email address will not be published. Required fields are marked *